| |
TM 9-2320-364-34-2
7-10
Materials/Parts
Oil, Hydraulic (Item 34, Appendix B)
Tags, Identification (Item 72, Appendix B)
Packing, Preformed (Item 399, Appendix E)
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Condition
Transmission solenoid wiring harness
removed, (Para 7-2)
Tools and Special Tools
Tool Kit, General Mechanics
(Item 240, Appendix F)
Bit Set, Screwdriver (Item 17, Appendix F)
Wrench Set, Socket 3/8 in. Drive
(Item 273, Appendix F)
Wrench, Torque (0-60 N.m)
(Item 276, Appendix F)
7-7. TRANSMISSION SOLENOID REPLACEMENT.
a.
Removal.
NOTE
There are two different types of solenoids; six are the same, three are the same.
All nine solenoids are removed and installed the same way.
Tag, mark and note the position of solenoids and connectors prior to removal.
(1)
Disconnect connector (1) from solenoid
harness assembly (2).
(2)
Remove two screws and washers (3),
preformed packing (4) and solenoid (5)
from solenoid plate (6). Discard preformed
packing.
b.
Installation.
(1)
Apply hydraulic oil to preformed
packing (4).
(2)
Install preformed packing (4), solenoid (5)
and two screws and washer (3) on solenoid
plate (6). Tighten screws to 84 to 108 lb-in
(9 to 12 N.m).
(3)
Connect connector (1) on solenoid harness
assembly (2).
c.
Follow-On Maintenance:
Install transmission solenoid wiring harness,
(Para 7-2).
END OF TASK
|