| |
TM 9-2320-364-34-2
7-12
Materials/Parts
Adhesive (Item 1, Appendix B)
Adhesive (Item 2, Appendix B)
Grease, High Temperature (Item 23, Appendix B)
Oil, Hydraulic (Item 34, Appendix B)
Sealing Compound (Item 56, Appendix B)
Dust Shield (Item 41, Appendix E)
Locknut (Item 189, Appendix E)
Seal, Oil (Item 591, Appendix E)
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Personnel Required
Two
Equipment Condition
Engine OFF, (TM 9-2320-364-10)
Wheels chocked, (TM 9-2320-364-10)
Right side skirt removed, (TM 9-2320-364-20)
Tools and Special Tools
Tool Kit, General Mechanics
(Item 240, Appendix F)
Adapter, Socket (Item 10, Appendix F)
Handle, Driver (Item 92, Appendix F)
Installer, Output Shaft Seal
(Item 111, Appendix F)
Multiplier, Torque (Item 141, Appendix F)
Pan, Drain 4 gal (Item 144, Appendix F)
Puller, Mechanical (Item 173, Appendix F)
Wrench Set, Socket 3/4 in. Drive
(Item 274, Appendix F)
Wrench, Torque (0-175 lb-ft [0-237 N.m])
(Item 277, Appendix F)
Wrench, Torque (0-600 lb-ft [0-814 N.m])
(Item 278, Appendix F)
Holder, Flange (Appendix C)
Socket, Flange Nut (Appendix C)
7-9. TRANSMISSION YOKE/DUST SHIELD/OIL SEAL REPLACEMENT.
a.
Removal.
(1)
Matchmark driveshaft (1) with arrow
pointing towards front of truck.
Driveshaft weighs 90 lbs (41 kg).
The aid of an assistant is required
to prevent possible injury to
personnel.
NOTE
The aid of an assistant will be
required for Steps (2)
through (5).
(2)
Support driveshaft (1) and remove four
screws (2), two bearing straps (3) and
driveshaft (1) from Axle No. 2 yoke (4).
|