Quantcast Axle camber angle measurements - TM-9-2320-364-34-2_921

Order this information in Print

Order this information on CD-ROM

Download in PDF Format

     

Click here to make tpub.com your Home Page

Page Title: Axle camber angle measurements
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Combat
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
USMC
   
Products
  Educational CD-ROM's
Printed Manuals
Downloadable Books
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
b. Installation - TM-9-2320-364-34-2_920
Up
TM-9-2320-364-34-2 Palletized Load System (PLS) M1074/M1075 Manual
Next
Install air line 2359
TM 9-2320-364-34-2      9-87 (8) With the aid of an assistant, position axle end of torque rod (41) and air manifold bracket (40) on Axle No. 4 (26) with two screws (39), four washers (38) and two locknuts (37). Equalizer beams and frame must be level to perform axle camber adjustment properly. Axle camber angle measurements must be taken with relationship to frame.  If frame is not level, the angle the frame is inclined must be added or subtracted from flange assembly measurement. Axle flange measurement of 85 0.5 degrees equals axle camber of five degrees 0.5 (90 degrees – 85 degrees = 5 degrees). (9) Position protractor and steel plate on frame at point A.  Adjust protractor to zero. (10) Position protractor and steel plate on machined surface of the flange assembly and record measurement.  This is point B. Measurement should read 85 degrees 0.5 degrees. (11) Subtract measurement recorded at point B from 90 degrees.  This will be axle camber. Axle No. 4 and Axle No. 5 share mounting hardware for longitudinal torque rods.  Both axles must be supported during removal of screws and locknuts or axles may fall.  Failure to comply may result in injury or death to personnel. (12) If Axle No. 4 camber is not five degrees 0.5 degrees, support Axle No. 5 and add or subtract spacers (44) until correct axle camber is achieved. (13) Remove transmission jack from Axle No. 4 (26).

Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing

Integrated Publishing, Inc.
6230 Stone Rd, Unit Q Port Richey, FL 34668

Phone For Parts Inquiries: (727) 493-0744
Google +