| |
TM 9-2320-364-34-3
14-10
14-3. FRONT AND REAR SPRING ASSEMBLY REPLACEMENT (CONT).
(13)
Apply lubricating oil to threads of adjusting screws (8).
NOTE
Steps (14) through (17) apply to installing the rear spring assembly only.
Steps (18) through (20) apply to installing the front spring assembly only.
(14)
Install two nuts (7), lockwashers (9) and washers (10) on adjusting screws (8).
(15)
Position bracket (6) with two adjusting screws (8) on bracket (11). Tighten adjusting screws to 100 to
150 lb-ft (136 to 203 N.m).
(16)
Tighten two nuts (7) on adjusting screws (8) to 100 to 150 lb-ft (136 to 203 N.m).
NOTE
Adjusting rod is being temporarily installed at this time.
(17)
Connect adjusting rod (5) to bracket (6) with lockwasher (4) and old nut (3).
(18)
Install two nuts (7) and lockwashers (9) on each screw (8).
(19)
Install two adjusting screws (8) on bracket (11). Tighten adjusting screws to 100 to 150 lb-ft
(136 to 203 N.m).
(20)
Tighten two nuts (7) on adjusting screws (8).
(21)
Repeat Steps (1) through (20) for remaining spring.
|