Tag wear pads as to side and
extension. Note location and
quantity of any shims.
Remove two screws (59) and upper rear
wear pads (60) from outer-mid section
(40). Discard wear pads.
There may be a washer
behind wear pad. Tag and
mark after removal.
Remove side wear pads (61) and washer
from outer-mid section (40). Discard wear
Do not pull fly assembly out
more than four in. (102 mm) to
remove trunnion, or damage to
equipment may result.
Trunnion on right side has
milled surface to provide
There are two washers on
left side and one on right
Remove eight screws (62) and washers
(63) from outer-mid section (40).
Pull fly assembly (64) back and remove left
trunnion plate (65), two washers (66), right
trunnion plate (67) and washer (68) from
fly assembly (64).