|
| |
TM 9-2320-364-34-3
16-80
16-10. TELESCOPE CYLINDER REPLACEMENT (CONT).
Cable must be retracted slowly to prevent damage to sensing unit. Failure to comply may
result in damage to equipment.
NOTE
Mark the top and bottom of retaining pin. Bottom has threaded hole to accommodate
screw. Also note if pin holds overload shutdown cable.
Perform Step (7) if overload shutdown cable is attached to telescope cylinder.
(7)
Remove screw (13), cable (14), spacer (15) and washer (16) from retaining pin (17) and slowly let cable
retract.
(8)
Remove two cotter pins (18) and retaining pin (17) from boom base (11). Discard cotter pins.
(9)
Loosen screws (19) from top retaining plate (20).
|
