16-30. LEFT SIDE AND RIGHT SIDE CRANE REMOTE CONTROL CABLE
CONNECTOR REPAIR (CONT).
Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles, face
shield, and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and
clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when
using solvent. The flashpoint for Type II Drycleaning Solvent is 140 degrees F (60 degrees
C) and Type III Drycleaning Solvent is 200 degrees F (93 degrees C). Failure to do so may
result in injury or death to personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts
eyes, immediately flush eyes with water and get immediate medical attention.
Wash metal parts in drycleaning solvent.
Dry with cleaning cloth.
Inspect for damaged parts, frayed or broken wires. Test wires for continuity.
Replace damaged parts.
Position connector cap (1), ring (2),
grommet (3), connector (4) and conduit (5)
on cable (7).
Perform Step (2) if pins are
Install 14 pins (9) on wires (8).
Install 14 wires (8) in receptacle connector
Install conduit (5), connector (4),
grommet (3), ring (2) and connector cap (1)
on receptacle connector body (6).