16-33. CRANE CONTROL VALVES REPAIR (CONT).
Lever may have to be operated to
install lever end cap.
Apply hydraulic oil to preformed
Align matchmarks and install preformed
packing (10) and lever end cap (4) on valve
body (7) with four screws (9).
Install seal washer (6) and screw (5) in lever
end cap (4).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
Apply sealing compound to threads of
lever (3). Install lever, nut (1) and knob (2)
on lever end cap (4). Tighten nut against
Four function control valve bank, (Para 16-26).
Three function control valve bank, (Para 16-27).
Two function control valve bank, (Para 16-28).
Load test crane, (Para 16-32).
Remove wheel chocks, (TM-2320-364-10).
END OF TASK