|
| |
TM 9-2320-364-34-3
18-22
18-2. ENGINE ARCTIC KIT INSTALLATION (CONT)
(116)
Install negative battery post terminal (125)
to battery cable 1137 (129) with
lockwasher (126), nut (127) and screw (128).
(117)
Install positive terminal (130) to battery
cable 1137 (129) with lockwasher (126),
nut (132) and screw (128).
(118)
Position two batteries (131) and (132) in
battery box (114).
(119)
Install two battery holders (133) to two
carrier bolts (134) with four washers (135)
locknuts (136).
(120)
Install cable 1137 (129) to positive battery
terminal (137) on battery (132).
(121)
Install cable 1139 (117) to positive
terminal (138) on battery (131).
(122)
Install cable 1138 (116) to negative
terminal (139) on battery (132).
(123)
Install cable 1137 (129) to negative
terminal (140) on battery (131).
(124)
Tighten four nuts (127) on two positive
terminals (130) and negative
terminals (125).
Corrosion compound contains
alkali. Do not get in eyes; wear
safety goggles/glasses when
using. Avoid contact with skin. In
case of contact, immediately
wash area with soap and water. If
eyes are contacted, flush with
large amounts of water for at
least 15 minutes and get
immediate medical attention.
(125)
Apply anticorrosion compound on positive
terminals (137), (138) and negative
terminals (139) and (140).
(126)
Install cover (141) to battery box (114).
(127)
Drill four 1/8 in. holes in front access
cover (12) as shown.
(128)
Install data plate (142) to front access
cover (12) with four rivets (143).
|
