18-13. CONTAINER HANDLING UNIT (CHU) KIT INSTALLATION (CONT).
Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles, face
shield, and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and
clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when
using solvent. The flashpoint for Type II Drycleaning Solvent is 140 degrees F (60 degrees
C) and Type III Drycleaning Solvent is 200 degrees F (93 degrees C). Failure to do so
may result in injury or death to personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts
eyes, immediately flush eyes with water and get immediate medical attention.
Clean preservative from right rear roller
bracket (125) with dry cleaning solvent.
Arm assemblies are installed the
same way. Right side shown.
From CHU kit crate, unbolt and remove
wood blocking between arm assemblies
Arm assembly weighs 240 lbs
(109 kg). Attach suitable lifting
device to prevent possible injury
Attach lifting device to lifting bracket (159)
on right arm assembly (158) and remove
from CHU kit crate.