|
| |
TM 9-2320-364-34-4
28-84
28-15. SELF-RECOVERY WINCH MOTOR END SUPPORT REPAIR (CONT).
d.
Assembly.
(1)
Lubricate bearing (8) and shifter arm (5)
with hydraulic oil
(2)
Install bearing (8) in motor end support (1).
(3)
Place motor end support (1) on side and
install vent (9).
(4)
Coat two preformed packings (10) with
hydraulic oil.
(5)
Install two preformed packings (10) on
shifter arm (5).
(6)
Install gear drive shifter (7) in motor end
support (1). Position gear drive shifter (7)
so groove is aligned with hole for shifter
arm (5) tab.
(7)
Install shifter arm (5) until fully seated in
groove of gear drive shifter (7).
(8)
Coat preformed packing (6) with hydraulic
oil.
(9)
Install preformed packing (6) on motor end
support (1).
(10)
Install roll pin (4) in shifter arm (5).
e.
Installation.
(1)
Lubricate sun gear primary shaft (3) with
hydraulic oil.
(2)
Install sun gear primary shaft (3) in gear
end (2), splined end down.
NOTE
Ensure roll pin is fully seated in
shifter arm assembly.
(3)
Install motor end support (1) on gear
end (2), bearing side down, until fully
seated.
f.
Follow-On Maintenance:
Install Self-Recovery Winch base mounts,
(Para 28-14).
END OF TASK
|
