|
| |
TM 9-2320-364-34-4
C-26
C-25. TURBOCHARGER HOLDING FIXTURE.
Fabricate from 3/4 in. (19 mm) exterior grade plywood.
a.
Drill 1 1/2 in. (38 mm) diameter hole in center of base.
b.
Drill four 1/2 in. (13 mm) diameter holes in corners of base.
c.
Draw a circle with a 1 5/8 in. (41 mm) radius.
d.
Route four 1/2 in. (13 mm) x 3/4 in. (19 mm) slots in base into circle as shown.
e.
Fabricate two 1 15/16 in. (49 mm) x 2 1/2 in (63.5 mm) x 1 1/4 in. (32 mm) fingers from plywood.
f.
Grind bottom of fingers 23/32 in. (18 mm) wide and 7/16 in. (11 mm) high. Contour front surface of fingers to
fit turbine wheel blades.
|
