Order this information in Print

Order this information on CD-ROM

Download in PDF Format

     

Click here to make tpub.com your Home Page

Page Title: b. Hoses and Fittings
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Combat
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
USMC
   
Products
  Educational CD-ROM's
Printed Manuals
Downloadable Books
   

 

TM 9-2320-364-34-4 D-3 b. Hoses and Fittings. NOTE Most fluid piping system sizes are measured by dash numbers.  These are universally used abbreviations for the size of the component expressed as the numerator of the fraction with the denominator always being 16.  For example, a -04 port is 4/16 or 1/4-inch.  Dash numbers are usually nominal (in name only) and are abbreviations that make ordering of components easier. (1) Measure the I.D./O.D. diameter with a caliper as shown. (2) Under the heading MALE THREAD O.D. and FEMALE THREAD I.D., match the measurements with the row in table to determine proper torque. (3) To find the sealing surface angle, use a protractor and measure the sealing surface parallel to the center line of the fitting. (FEMALE THREADS) I.D. 0 (MALE THREADS) O.D. 2 0 SEALING SURFACE CENTER LINE OF FITTING 37

Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business