|
| |
TM 9-2320-364-34-4
20-99
(6)
Install four screws (5) in front main bearing
cap (12) and rear main bearing cap (13).
(7)
Tighten four screws (5) on bearing caps (12)
and (13) to 50 lb-ft (68 N.m).
(8)
Strike front main bearing cap (12) and rear
main bearing cap (13) with soft plastic
hammer.
(9)
Tighten four screws (5) on bearing caps (12)
and (13) 110 lb-ft (149 N.m).
(10)
Strike front main bearing cap (12) and rear
main bearing cap (13) with soft plastic
hammer.
(11)
Tighten four screws (5) on bearing caps (12)
and (13) 250 to 260 lb-ft (339 to 353 N.m).
NOTE
Bearing caps are numbered from
one to five for later installation.
(12)
Remove three center bearing caps (14)
from crankshaft (2).
(13)
Remove lower bearing shells (15) from
three center bearing caps (14).
|
