|
| |
TM 9-2320-364-34-4
20-250
20-72. REAR CYLINDER BLOCK PLATE INSTALLATION (CONT).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in a well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
(4)
Coat block plate gasket (4) with sealing
compound and install over dowel pins (5) on
engine block (6).
(5)
Position block plate (1) on dowel pins (5).
(6)
Position four screws (7) in block plate (1).
(7)
Position lockwasher (8) and screw (9) in
block plate (1).
(8)
Position camshaft front end bearing (10) as
a guide in block plate (1).
(9)
Tighten four screws (7) 30 to 35 lb-ft
(41 to 47 N.m).
(10)
Tighten screw (9) 103 to 110 lb-ft
(140 to 149 N.m).
(11)
Remove camshaft front end bearing (10)
from block plate (1).
b.
Follow-On Maintenance:
Install camshaft assembly, (Para 20-73).
END OF TASK
|
