|
| |
TM 9-2320-364-34-4
20-305
(6)
Unscrew connector (8) from drone (2)
until connector (8) covers preformed
packing (9) and makes contact with
service brake (7).
(7)
Back off connector (8) 1/3 turn and hold
connector (8) while tightening nut (10)
against drone (2).
(8)
Repeat Steps (1) through (7) for remaining
brake sets.
NOTE
Both engine brake wire
harnesses are installed the
same way.
Install cable ties as noted
during removal.
(9)
Position engine brake harness (11) in
cylinder head (6).
(10)
Install terminal assembly (12) in cylinder
head (6).
(11)
Connect spade connector (13) on terminal
assembly (12).
(12)
Connect spade connector (14) on terminal
assembly (12).
(13)
Install rubber harness support (15) on
injector lines (16).
(14)
Connect positive lock connectors (17) on
engine brake solenoids (18).
b.
Follow-On Maintenance:
Perform engine tune-up adjustments,
(Para 20-94).
END OF TASK
|
