|
| |
TM 9-2320-364-34-4
20-310
Materials/Parts
Grease (Item 21, Appendix B)
Sealing Compound (Item 53, Appendix B)
Sealing Compound (Item 56, Appendix B)
Gasket (Item 76, Appendix E)
Gasket (Item 100, Appendix E)
Lockwasher (5) (Item 292, Appendix E)
Seal (Item 574, Appendix E)
Snap Ring (Item 648, Appendix E)
This task covers:
a. Installation
b. Follow-On Maintenance
INITIAL SETUP
Equipment Condition
Engine tune-up adjustments completed,
(Para 20-94)
Tools and Special Tools
Tool Kit, General Mechanic’s
(Item 240, Appendix F)
Alignment Tool, Blower (Item 12, Appendix F)
Wrench, Torque (0 to 175 lb-ft [0-237 N.m])
(Item 277, Appendix F)
Lifting Device Minimum Capacity
100 lbs (45 kg)
20-95. BLOWER ASSEMBLY INSTALLATION.
a.
Installation.
(1)
Apply grease to bottom side of gasket (21).
(2)
Position gasket (21) on engine block (22).
(3)
Position seal (23) and clamp (4) on blower
drive hub (3).
Blower weighs 71 lbs (32 kg).
Attach suitable lifting device for
installation to prevent possible
injury to personnel.
(4)
Install lifting device on blower assembly (2).
(5)
Position blower assembly (2) on gasket (21).
Remove lifting device.
(6)
Position four washers (17) and screws (16)
on blower (2).
(7)
Position six retainers (20), bracket (19) and
screws (18) on blower (2).
|
