|
| |
TM 9-2320-364-34-4
20-314
Materials/Parts
Oil, Lubricating (Item 36, Appendix B)
Gasket (Item 74, Appendix E)
Mount, Resilient (2) (Item 306, Appendix E)
This task covers:
a. Installation
b. Follow-On Maintenance
INITIAL SETUP
Equipment Condition
Tachometer drive installed, (Para 20-96)
Tools and Special Tools
Tool Kit, General Mechanic’s
(Item 240, Appendix F)
Wrench, Torque (0 to 175 lb-ft [0-237 N.m])
(Item 277, Appendix F)
20-97. ROCKER COVER INSTALLATION.
a.
Installation.
NOTE
Right and left rocker covers are
installed in the same way. Left
side shown.
(1)
Press stem side of gasket (6) down into
groove at four corners of rocker cover (4).
(2)
Press remainder of gasket (6) into place in
groove of rocker cover (4). Ensure gasket is
seated.
(3)
Lubricate cylinder head (5) rail and flat
surface of gasket (6) with light coating of
lubricating oil.
(4)
Position rocker cover (4) on cylinder
head (5).
(5)
Install two resilient mounts (3), washers (2)
and screws (1). Tighten screws to
15 to 21 lb-ft (20 to 28 N.m).
b.
Follow-On Maintenance:
Install fuel pump assembly, (Para 20-98).
END OF TASK
|
