|
| |
TM 9-2320-364-34-4
20-361
NOTE
Any wires already mounted on
the negative terminal must stay
on that terminal during
installation.
(63)
Remove nut (46) from negative
terminal (49).
(64)
Install wire 1815 (48), lockwasher (47) and
nut (46) on negative terminal (49).
Adhesives, solvents, and sealing
compounds can burn easily can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in a
well-ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and water.
(65)
Coat negative terminal (49) with electrical
sealant.
Starter weighs 73 lbs (33 kg).
Attach suitable lifting device
prior to installation to prevent
possible injury to personnel.
(66)
Using a lifting device, install gasket (45),
starter (40) in flywheel housing (44) with
three lockwashers (42) and screws (41)
through starter mounting bracket (43).
Tighten screws to 137 to 147 lb-ft (186 to
199 N.m).
(67)
Remove lifting device from starter (40).
(68)
Remove nuts (37) and (33) from starter (40)
(69)
Install wire 1818 (39) on starter (40) with
lockwasher (38) and nut (33). Tighten nut
to 30 lb-ft (41 N.m).
(70)
Install wire 1816 (35) on starter solenoid
(36) with lockwasher (34) and nut (33).
Coat terminal with electrical sealant.
|
