|
| |
TM 9-2320-364-34-4
21-19
NOTE
If clearance cannot be obtained at
points (D) and (E), replace entire
blower assembly.
(48)
Rotate rotors (30) and (31) to align lobes
with points (D). Measure clearance at
points (D). Minimum clearance is 0.015 in.
(0.381 mm).
(49)
Measure clearance at points (E). Minimum
clearance is 0.009 in. (0.228 mm).
(50)
Remove four screws (29) and washers (28) from front end plate (6) and four screws (29) and washers (28)
from rear end plate (12).
(51)
Install oil slinger (32) on rotor shaft (7) at front end plate (6).
NOTE
Ensure tang on fuel pump disk locks into groove in spacer.
(52)
Install fuel pump disk (33), lockwasher (34) and screw (35) on rotor shaft (7).
(53)
Place clean shop towel between two rotors (30) and (31).
(54)
Bend one lockwasher (34) tab in groove of fuel pump disk (33).
|
