|
| |
TM 9-2320-364-34-4
23-24
23-8. TRANSMISSION SOLENOID WIRING HARNESS REPAIR (CONT).
d.
Assembly.
Use care when installing
retaining rings. Retaining rings
are under tension and can act as
projectiles when released
causing injury to personnel.
NOTE
Perform Step (1) if standoffs
were removed.
(1)
Install 11 standoffs (15) and retaining
rings (14) in solenoid wiring harness
assembly (5).
NOTE
Perform Step (2) if cable ties
were removed.
(2)
Install cable ties (12) on wiring harness
cable (13).
(3)
Apply hydraulic oil to three seals (8).
(4)
Install three seals (8) in each mounting
surface of three non-latching solenoids (7).
(5)
Install two screws with washers (6) and
three non-latching solenoids (7) to
solenoid wiring harness assembly (5).
Tighten to 84 to 108 lb-in (9 to 12 N.m).
(6)
Apply hydraulic oil to six seals (8).
(7)
Install six seals (8) in each mounting surface of six latching solenoids (4).
(8)
Align each solenoid (7) and (4) on solenoid wiring harness assembly (5) in areas identified for latching
solenoids.
(9)
Install six latching solenoids (4) and two screws with washers (3) to solenoid wiring harness assembly (5).
Tighten to 84 to 108 lb-in (9 to 12 N.m).
(10)
Apply hydraulic oil to preformed packing (11).
(11)
Position preformed packing (11) on two pressure switches (10).
(12)
Install two pressure switches (10) on solenoid wiring harness assembly (5) with two screws (9). Tighten
screws to 60 to 84 lb-in (7 to 9 N.m).
(13)
Connect all solenoid and pressure sensor switch connectors (1) to circuit board terminals (2) on solenoid
wiring harness assembly (5).
|
