|
| |
TM 9-2320-364-34-4
23-46
23-11. TORQUE CONVERTER PUMP REPAIR (CONT).
d.
Assembly.
(1)
Coat grooves on hub (5) with grease.
(2)
Coat seal ring (8) with petrolatum and install
on hub (5).
Make sure that both bearing
races and bearing have same
serial number. Bearing races or
bearing with different serial
numbers will cause damage.
(3)
Install inner race (10) on hub (5).
(4)
Install hub (5) on torque converter
pump (4).
(5)
Install bearing (6) in inner race (10).
(6)
Install outer race (7) in torque converter
pump (4) until grooves in outer race are
clearing surface of torque converter pump.
(7)
Install two bearing retainers (3) in torque
converter pump (4) to fit in grooves of outer
race (7).
(8)
Position six lockstrips (1) and 12 screws (2)
in two bearing retainers (3).
Failure to tighten screws in
sequence shown may cause
damage to bearing.
(9)
With the aid of an assistant, tighten four
screws (2) in sequence shown to 33 to 40
lb-ft (45 to 54 N.m).
(10)
With the aid of an assistant, tighten
remaining eight screws (2) to 33 to 40 lb-ft
(45 to 54 N.m).
(11)
Bend corners of lockstrips (1) against heads
of screws (2).
|
