Quantcast b. Cleaning/Inspection. - TM-9-2320-364-34-4_594

Order this information in Print

Order this information on CD-ROM

Download in PDF Format

     

Click here to make tpub.com your Home Page

Page Title: b. Cleaning/Inspection.
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Combat
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
USMC
   
Products
  Educational CD-ROM's
Printed Manuals
Downloadable Books
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
23-20.  SECOND CLUTCH REPAIR.
Up
TM-9-2320-364-34-4 Palletized Load System (PLS) M1074/M1075 Manual
Next
Table 23-6. External-Tanged Clutch Plate Combination
TM 9-2320-364-34-4      23-135 b. Cleaning/Inspection. Drycleaning Solvent (P-D-680) is TOXIC and flammable.  Wear protective goggles, face shield, and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors.  Keep away from heat or flame.  Never smoke when using solvent. The flashpoint for Type II Drycleaning Solvent is 140 degrees F (60 degrees C) and Type III Drycleaning Solvent is 200 degrees F (93 degrees C).  Failure to do so may result in injury or death to personnel. If personnel become dizzy while using cleaning solvent, immediately get fresh air and medical help.  If solvent contacts skin or clothes, flush with cold water.  If solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. (1) Clean all metal parts using drycleaning solvent. Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa).  Use only with effective chip guarding and personal protective equipment (goggles/shield, gloves, etc). Failure to comply may result in injury or death to personnel. (2) Dry all metal parts with compressed air. (3) Inspect all metal parts for nicks, burrs or scratches.  Replace damaged parts. (4) Inspect internal-splined plates for imbedded metal particles, severely pitted faces, cracks, distortion, and damaged or missing spline teeth.  Remove burrs using a soft honing stone.  Replace defective plates. (5) Discard internal-splined plates if oil groove is not visible. (6) Inspect external-tanged plates (1) for scoring, excessive wear, cone distortion, imbedded metal, cracks, breaks, and damaged or missing tangs.  Remove burrs and minor surface irregularities using a soft honing stone.  Replace defective plates. (7) Measure distance between inside diameter of each external-tanged plate (1) and a level surface to determine cone.  Discard plates having a cone in excess of 0.013 in. (0.330 mm).

Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing

Integrated Publishing, Inc.
6230 Stone Rd, Unit Q Port Richey, FL 34668

Phone For Parts Inquiries: (727) 493-0744
Google +