|
| |
TM 9-2320-364-34-4
25-144
25-27. AXLE NO. 4 REAR OUTPUT ASSEMBLY REPLACEMENT (CONT).
(5)
Press output shaft (2) in output
housing (12).
(6)
Apply lubricating oil to preformed
packing (13).
(7)
Install preformed packing (13) in axle
housing (6).
NOTE
If installation of shaft is difficult,
have assistant pull outward on
lockup fork.
(8)
Install output shaft (2) in axle housing (6).
Adhesives, solvents and sealing compounds can burn easily, can give off harmful vapors and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
(9)
Coat mating surfaces of cover (9) with adhesive.
NOTE
Shim thickness was determined in Steps (2) through (4).
(10)
Install adjusting shim (10) on cover (9).
(11)
Coat threads of two screws (7) with adhesive.
(12)
Install cover (9) with two washers (8) and screws (7) on axle housing (6). Tighten screws to 90 lb-ft
(122 N.m).
NOTE
Perform Step (13) if grease fittings were removed from cover.
(13)
Install two grease fittings (11) in cover (9).
|
