|
| |
TM 9-2320-364-34-4
25-160
25-28. AXLE NO. 3 DIFFERENTIAL ASSEMBLY REPAIR (CONT).
d.
Assembly.
(1)
Using press, install bearing (75) on output
shaft (73).
(2)
Install output shaft (73) in output
housing (74).
Adhesives, solvents and sealing
compounds can burn easily, can
give off harmful vapors and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
(3)
Coat threads of nut (72) with sealing
compound.
(4)
Using spanner socket, install nut (72).
Tighten nut to 253 lb-ft (343 N.m).
NOTE
Perform Steps (5) through (11)
only if a new pinion shaft and
differential bevel gear are being
installed.
The machined conical distance
is engraved on pinion shaft
head.
(5)
Record machined conical distance of used
pinion shaft (1) removed from differential
assembly.
(6)
Record machined conical distance of new
pinion shaft (1) to be installed in the
differential assembly.
(7)
Compare two distances recorded in Steps (5)
and (6). If distance recorded in Step (5) is
larger than distance recorded in Step (6),
proceed to Step (8). If distance recorded in
Step (6) is larger than distance recorded in
Step (5), proceed to Step (9).
|
