|
| |
TM 9-2320-364-34-4
26-10
26-2. AIR COMPRESSOR REPAIR (CONT).
c.
Assembly.
NOTE
Tab on thrust washer must face forward and fit in upper slot of crankcase housing.
Install all parts as noted during removal.
(1)
Position thrust washer (40) on crankshaft (26) and install crankshaft in crankcase (17).
(2)
With the aid of an assistant, install key (39), gear (38) and gear nut (37) on crankshaft (26). Tighten gear
nut to 80 lb-ft (108 N.m).
(3)
Install gasket (36) and end cover (35) on crankcase (17) with four screws (33) and lockwashers (34).
NOTE
Locating tabs on bearing halves
should be installed in notches on
connecting rods.
(4)
Install four upper bearing halves (32) in
connecting rods (25).
(5)
Coat bores of cylinder block (5), four
pistons (31) and bearing halves (32) with
lubricating oil.
(6)
Using ring compressor, install four
pistons (31) and connecting rods (25) as
assemblies in cylinder block (5).
|
