|
| |
TM 9-2320-364-34-4
26-11
(7)
Position gasket (30) on cylinder block (5).
Ensure not to score cylinder
bores or crankshaft journals with
ends of connecting rods or
equipment may be damaged.
(8)
With the aid of an assistant, position
crankcase (17) on gasket (30) and cylinder
block (5) and position connecting rods (25)
on to journals of crankshaft (26).
(9)
Position crankcase (17) and cylinder
block (5) with crankcase (17) side down.
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in a well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
(10)
Apply sealing compound to threads of
screws (28).
(11)
Install ten lockwashers (29) and screws (28)
on cylinder block (5). Tighten screws to 96
lb-in (11 N.m) in sequence shown.
Retighten again 27 to 33 lb-ft (37 to 45 N.m).
NOTE
Perform Step (12) if plugs were
removed.
(12)
Coat threads of six plugs (27) with sealing
compound and install in crankcase (17).
(13)
Position crankcase (17) and cylinder
block (5) with crankcase (17) side up.
|
