|
| |
TM 9-2320-364-34-4
28-33
Use care when removing
retaining rings. Retaining rings
are under tension and can act as
projectiles when released causing
injury to personnel.
NOTE
Use care when removing gear, or
rollers may fall.
(14)
Remove lock ring (26), shaft (27), two
washers (28), gear (29), 34 roller
bearings (30) and retaining ring (31) from
planetary (18). Discard lock ring.
(15)
Repeat Step (14) for two remaining
gears (29).
(16)
Remove washer (32) from planetary (18).
(17)
Remove eight screws (33), washers (34) and
drum end (7) from ring gear (11).
(18)
Remove and discard preformed packing (35)
from drum end (7).
(19)
Remove oil seal (36) and bearing (37) from
drum end (7). Discard oil seal.
b.
Cleaning/Inspection.
Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles, face
shield, and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and
clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when
using solvent. The flashpoint for Type II Drycleaning Solvent is 140 degrees F (60 degrees
C) and Type III Drycleaning Solvent is 200 degrees F (93 degrees C). Failure to do so may
result in injury or death to personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts
eyes, immediately flush eyes with water and get immediate medical attention.
|
