3-5. SPARE TIRE REPLACEMENT (CONT).
Remove cable (16) from pulley
Remove safety clip (12) and pin (13) from
pulley assembly (14).
Retract pulley assembly (14) to stow
position in support (15) and install pin (13)
and safety clip (12) in pulley assembly.
Change tire (Para 3-4).
Ensure all personnel wear suitable eye protection while raising spare tire. Failure to
comply may result in injury to personnel.
Ensure personnel are positioned under trailer only far enough to perform procedure. Do
not position entire body under tire unless required. Failure to comply may result in injury
or death to personnel.
Tire weighs 425 lbs (193 kg). Keep all personnel clear from under tire. Failure to comply
may result in serious injury to personnel.
Wheel/tire must be inflated in a safety cage or personal injury or death may result.
Position spare tire (1) on flat surface with
inside of rim (2) facing upward.
Ensure lift assembly does
not enter stud holes in rim
of spare tire or spare tire
will not be installed properly
on spare tire bracket.
To prevent knotting and
binding ensure there is
tension on cable when
reeling it in. Failure to
comply may result in
damage to equipment.
Install lift assembly hook (3) in stud hole (4)
of spare tire (1).