INTRODUCTION TO LOGIC TREE TROUBLESHOOTING.

TM 9-2330-385-14

4-11. INTRODUCTION TO LOGIC TREE TROUBLESHOOTING (CONT).

(b)

Set the function/range switch to the desired ohm position. If the magnitude of the resistance is not

known, set the switch to the highest range, then reduce until a satisfactory reading is obtained.

(c)

Connect test leads to the circuit being measured. When measuring high resistance, be careful not to

contact adjacent points, even if they are insulated. Some insulators have a relatively low insulation

resistance which can affect the resulting measurement.

(d)

Read the resistance value on the digital display.

(2)

Continuity Checks.

(a)

Place the function/range switch in any ohm range.

NOTE

Some meters show "1+m", or simply "1" when function/range switch is in any ohm

position.

(b)

Connect the red lead to the volt-ohm connector and black lead to COM input connector on the

meter. When the test leads separated or measuring and out-of-range resistance, the digital display

will indicate Over-Limit (OL).

(c)

Put one test probe at one end of the wire or circuit to be tested. Use the other test lead to trace the

circuit. When continuity is established, an ohm symbol will appear in the upper left corner of the

digital display. If contact in the wire is maintained long enough (about 1/4 of a second), the OL will

disappear and the resistance value of the wire or circuit will appear next to the symbol.

(d)

If your multimeter does not work in this manner, carefully read the manufacturer's operating manual

for proper operational procedures before performing troubleshooting.

(3)

Voltage Measurements.

(a)

Connect the red test lead to the volt-ohm input connector and the black lead to the COM input on

the meter. If a DC-AC switch is present, make sure it is switched to the DC position.

(b)

Set the function/range switch to the desired volts position. If the magnitude of the voltage is not

known, set the switch to the highest DC voltage range. Then reduce the range until a satisfactory

reading is obtained.

(c)

Connect the test leads to the circuit being measured. Following the voltage measurement points, the

color test lead used is given in parenthesis (red is the positive volt-ohm connection, and black is the

negative COM connection).

4-12. UNIT TROUBLESHOOTING PROCEDURES.

Refer to Table 4-2 for a list of common malfunctions which are found in the troubleshooting procedures. The

troubleshooting procedures contain test and inspection instructions required to determine the malfunction's cause and

corrective actions for repairing the faulty equipment. Before troubleshooting, be sure all Preventive Maintenance

Checks and Services (PMCS) have been performed. Try to return the component to operation after each test,

inspection and correction action has been performed.

4-22