REAR MARKER LIGHT(S) DO NOT OPERATE. (Cont) -725550177

TM 9-2330-385-14

Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical

circuits, a direct short may result. Damage to equipment, injury, or death to personnel may occur.

CONTINUITY TEST

(1) Set multimeter select switch to ohms.

(2) Is there continuity between rear

marker light socket ground and a

known good ground?

(a) If there is no continuity,

replace rear marker light

(b) If there is continuity, rear marker

light is OK. Fault not corrected.

Notify supervisor.

(3) Install marker light lamp.

(4) Install light lens and two screws.

CONTINUITY TEST

(1) Disconnect wire 1012-31 connector

from rear marker light connector.

(2) Is there continuity measured between

center contact of marker light socket

and connector?

(a) If there is no continuity,

replace marker light (Para 4-28).

(b) If there is continuity, marker light

is OK.

(3) Connect wire 1012-31 connector to

rear marker light connector.

(4) Install marker light lamp.

(5) Install light lens and two screws.