Alternate Flatrack Stacking Procedure.

TM 9-3990-206-14&P

Alternate Flatrack Stacking Procedure.

Flatracks must be empty when stacked. Attempting to stack loaded flatracks could cause

serious injury or death to personnel.

Rollers must be installed on flatrack prior to performing this procedure. Failure to comply

could result in damage to equipment.

NOTE

This procedure can be performed with one vehicle.

Tiedown rings must be off top of bed prior to performing this procedure.

(1)

Position PLS truck No. 1 (1) in front of flatrack No. 1 (2).

Push up and turn handle (3) on two front locks (4) to UNLOCK position as shown.

(2)

(3)

Remove pin (5) from rear extension (6) and rotate extension (6) outward.

(4)

Install pin (5) to secure rear extension (6) in place.

2-18.2