Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles, face
shield, and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and
clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when
using solvent; the flashpoint for Type II Drycleaning Solvent is 140 degrees F (60 degrees C)
and Type III Drycleaning Solvent is 200 degrees F (93 degrees C). Failure to do so may
result in injury or death to personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts
eyes, immediately flush eyes with water and get immediate medical attention.
Visually inspect all components for dirt or other contamination and clean with a lint-free cloth and
Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa). Use only with
effective chip guarding and personal protective equipment (goggles/shield, gloves, etc) or
severe injury or death could result.
Dry components with compressed air.
Inspect lockwires and retaining rings for damage. Refer to Appendix G, Manufactured Items List, for
Inspect roller for damage that would interfere with rotation.
Perform Step (1) if retaining pins
Install retaining pins (6) on holding pins (7).
Install roller (4) in bracket (5) and secure
with roller shaft (3).
Install collar (2) on roller shaft (3).
Secure collar (2) on roller shaft (3) with roll
Install roller, (Para 3-2).
END OF TASK