Quantcast Disassembly. -724650095

 

Click here to make tpub.com your Home Page

Page Title: Disassembly.
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
REAR ISO LOCK REPAIR.
Up
TM-9-3990-206-14-P Palletized Load System (PLS) FlatrackM1074/M1075 Manual
Next
Cleaning/Inspection. -724650096
TM 9-3990-206-14&P
CARC paint contains isocyanate (HDI) which is highly irritating to skin and respiratory
system. High concentrations of HDI can produce symptoms of itching and reddening of skin, a
burning sensation in throat and nose and watering of the eyes. In extreme concentrations, HDI
can cause cough, shortness of breath, pain during respiration, increased sputum production, and
chest tightness. The following precautions must be taken whenever using CARC paint:
ALWAYS use air line respirators when using CARC paint unless air sampling shows
exposure to be below standards. Use chemical cartridge respirator if air sampling is below
standards.
DO NOT let skin or eyes come in contact with CARC paint. Always wear protective
equipment (gloves, ventilation mask, safety goggles, etc.).
DO NOT use CARC paint without adequate ventilation.
NEVER weld or cut CARC-coated materials.
DO NOT grind or sand painted equipment without high-efficiency air purifying respirators
in use.
BE AWARE of CARC paint exposure symptoms; symptoms can occur a few days after
initial exposure. Seek medical help immediately if symptoms are detected.
(3)
Using a wire scratch brush, remove CARC
paint from area four in. (102 mm) around
cutting point.
(4)
Cut weldment and remove chain (6) and pin
2
(1) from pivot pin (7).
9
7
6
(5)
Remove chain (6) from pin (1).
(6)
Using a wire scratch brush, remove CARC
paint from area four in. (102 mm) around
cutting point.
(7)
Cut weldment and remove chain (8) and pin
(4) from pin (9).
8
1
(8)
Remove chain (8) from pin (4).
3
(9)
Cut weldment and remove pivot pin (7) and
extension (2) from flatrack (3).
4
5-11

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.
6230 Stone Rd, Unit Q Port Richey, FL 34668

Phone For Parts Inquiries: (727) 493-0744
Google +