Cleaning/Inspection. -724650192

TM 9-3990-206-14&P

9-21. PIN ASSEMBLY AND BRACKET REPAIR (CONT).

Cleaning/Inspection.

Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles, face

shield, and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and

clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when

using solvent; the flashpoint for Type II Drycleaning Solvent is 140 degrees F (60 degrees C)

and Type III Drycleaning Solvent is 200 degrees F (93 degrees C). Failure to do so may

result in injury or death to personnel.

If personnel become dizzy while using cleaning solvent, immediately get fresh air and

medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts

eyes, immediately flush eyes with water and get immediate medical attention.

(1)

Clean all parts with dry cleaning solvent and clean lint-free cloth.

Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa). Use only with

effective chip guarding and personal protective equipment (goggles/shield, gloves, etc) or

severe injury or death could result.

(2)

Dry all parts with compressed air.

(3)

Inspect all parts for damage that would impair operation.

(4)

Inspect pin for roughness or gouging.

(5)

Inspect nut and stud pin for bad threads.

(6)

Discard all damaged parts.

Assembly.

(1)

Install stud pin (17) in pin (14) with two roll

pins (15) and (16).

(2)

Lubricate preformed packing (18) with

lubricating oil.

(3)

Install preformed packing (18) in pin (14).

9-52