Quantcast EXPLANATION OF COLUMNS IN TOOL AND TEST EQUIPMENT REQUIREMENTS, SECTION IV.

 

Click here to make tpub.com your Home Page

Page Title: EXPLANATION OF COLUMNS IN TOOL AND TEST EQUIPMENT REQUIREMENTS, SECTION IV.
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
MAINTENANCE FUNCTIONS -724650226
Up
TM-9-3990-206-14-P Palletized Load System (PLS) FlatrackM1074/M1075 Manual
Next
Section II. MAINTENANCE ALLOCATION CHART (MAC) FOR FLATRACK M1077/M1077A1
TM 9-3990-206-14&P
d.  Column 4, Maintenance Level. Column 4 specifies, by the listing of a work time figure in the appropriate
subcolumn(s), the level of maintenance authorized to perform the function listed in Column 3. This figure represents
the active time required to perform that maintenance function at the indicated level of maintenance. If the number or
complexity of the tasks within the listed maintenance function vary at different maintenance levels, appropriate work
time figures will be shown for each level. The work time figure represents the average time required to restore an
item (assembly, subassembly, component, module, end item, or system) to a serviceable condition under typical field
operating conditions. This time includes preparation time (including any necessary disassembly/assembly time),
troubleshooting/fault location time, and quality assurance/quality control time in addition to the time required to
perform the specific tasks identified for the maintenance functions authorized in the Maintenance Allocation Chart.
The symbol designations for the various maintenance levels are as follows:
C  Operator or Crew
H General Support Maintenance
O Unit Maintenance
F  Direct Support Maintenance
e.  Column 5, Tools and Equipment. Column 5 specifies, by code, those common tool sets (not individual
tools) and special tools, TMDE, and support equipment required to perform the designated function.
f.  Column 6, Remarks. This column shall, when applicable, contain a letter code in alphabetic order, which
shall be keyed to the remarks contained in Section IV.
B-4. EXPLANATION OF COLUMNS IN TOOL AND TEST EQUIPMENT
REQUIREMENTS, SECTION IV.
a.  Column 1, Reference Code. The tool and test equipment reference code correlates with a code used in the
MAC, Section II or III, Column 5.
b.  Column 2, Maintenance Level. The lowest category of maintenance authorized to use the tool or test
equipment.
Column 3, Nomenclature. Name or identification of the tool or test equipment.
c.
Column 4, National Stock Number. The national stock number of the tool or test equipment.
d.
Column 5, Tool Number. The manufacturer's part number.
e.
B-5. EXPLANATION OF COLUMNS IN REMARKS, SECTION V.
a.  Column 1, Reference Code. An alphabetic code listed in the sixth column of the MAC and first column of
the Remarks section to identify remarks made to the MAC.
Column 2, Remarks. The complete text of the remarks made to the MAC.
b.
B-3

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.