SPECIAL INFORMATION.

TM 9-3990-206-14&P

F-4. EXPLANATION OF COLUMNS (SECTION IV) (CONT).

b. PART NUMBER INDEX. Part numbers in this index are listed by part number in ascending alphanumeric

sequence (i.e., vertical arrangement of letter and number combination which places the first letter or digit of each

group in order A through Z, followed by the numbers 0 through 9 and each following letter or digit in like order).

(1) CAGEC column. The Commercial and Government Entity Code (CAGEC) is a 5-digit numeric code used

to identify the manufacturer, distributor, or Government agency, etc., that supplies the item.

(2) PART NUMBER column. Indicates the primary number used by the manufacturer (individual, firm,

corporation, or Government activity), which controls the design and characteristics of the item by means of its

engineering drawings, specifications, and inspection requirements to identify an item or range of items.

(3) STOCK NUMBER column. This column lists the NSN for the associated part number and manufacturer

identified in the PART NUMBER and CAGE columns to the left.

(4)

FIG. column. This column lists the number of the figure where the item is identified/located in Sections II

and III.

(5) ITEM column. This item number is that number assigned to the item as it appears in the figure referenced

in adjacent figure number column.

F-5. SPECIAL INFORMATION.

a. USABLE ON CODE. The usable on code appears in the lower left corner of the Description column heading.

Usable on codes are shown as "UOC...." in the Description Column (justified left) on the last line applicable item

description/nomenclature. Uncoded items are applicable to all models. Identification of the usable code in this

publication is:

Code

Used On

077

Flatrack, Model M1077/M1077A1

IPF

ISO Compatible Palletized Flatrack M1 (IPF)

F-6. HOW TO LOCATE PARTS.

When National Stock Number or Part Number is NOT Known.

(1) First. Using the table of contents, determine the assembly group or subassembly group to which the item

belongs. This is necessary since figures are prepared for assembly groups and subassembly groups, and listings are

divided into the same groups.

(2)

Second. Find the figure covering the assembly group or subassembly group to which the item belongs.

(3)

Third. Identify the item on the figure and note the item number.

(4) Fourth. Refer to the Repair Parts List for the figure to find the part number for the item number noted

on the figure.

(5)

Fifth. Refer to the Figure and Item Number Index to find the NSN, if assigned.

F-6