Figure 35a. The Rear Side Cab Armor Panel installed.

II106700-5

Rev. B

Page 59

Figure 35a. The Rear Side Cab Armor Panel installed.

2. Position the Cab Entry Hand Hold on top of the Rear Side Cab Armor Panels and

secure it (and the Panels) in place using two bolts (7/16 - 14 x 4.000 LG),

four flat washers (7/16 ID), and two locknuts (7/16 14). Do not tighten the bolts

and nuts at this time.

NOTE

The gap between the rear edge of the Armored Door and the front edge of the

Rear Side Cab Armor Panels should be 1/8 to 3/16 in. wide.

3. Verify that the gap between the rear edge of the Armored Door and the front edge

of the Rear Side Cab Armor Panels is 1/8 to 3/16 in. wide.

0039 00-69