 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TB 9-2320-364-13&P-2
REAR CAB (LEFT) ARMOR REPLACEMENT - CONTINUED
0025 00
REMOVAL - CONTINUED
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
NOTE
Rear cab (left) armor weighs 100 lb (46 kg).
5.
Use lifting device to remove left rear cab armor (11) from vehicle.
6.
Remove lifting device, sling, and lifting link from left rear cab armor (11).
CLEANING AND INSPECTION
INSTALLATION
CAUTION
Secure all hoses, lines, and electrical harnesses near bottom of right-rear cab wall away from cab wall. Do
not allow rear cab (right) armor to rest on any hose, line, or electrical harness. Failure to follow this caution
will result in damage to vehicle.
1.
Check installation area of rear cab (right) armor for hoses, lines, and electrical harnesses. If necessary, reposition and
secure components away from rear cab (right) armor installation area.
2.
Install lifting link, sling, and lifting device in top-center hole of left rear cab armor (11).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
NOTE
Rear cab (left) armor weighs 100 lb (46 kg).
3.
Use lifting device to install left rear cab armor (11) on vehicle.
4.
Install six washers (10), bolts (9), washers (14), and new locknuts (15) on left rear cab armor (11).
5.
With assistance, install two armored washers (8), washer (7), bolt (6), washer (12), and new locknuts (13) on rear of cab.
6.
Install bracket (3), three washers (2), bolts (1), washers (4), and new locknuts (5) on top of left rear armor (11).
7.
Install roof armor (WP 0023 00).
8.
Connect battery cables (TM 9-2320-364-20).
END OF WORK PACKAGE
0025 00-3/(0025 00-4 Blank)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals