Install Armor Kit, Front, PLS, P/N 113370-1-103 (cont)

II113300-1-103

Rev. A

Page 68

o) In order to install the Headlight Assemblies, it is necessary to identify which type of

Marker Light is used on the vehicle. Before being removed, the Marker Light was

located just inboard of the Headlight. Inspect the Marker Light and determine whether

an incandescent bulb (i.e., a common lamp bulb) is used inside the light. If an

incandescent bulb is NOT found, use Configuration A as shown in Figure 51 and

Figure 52, and install the Headlight Assemblies using Steps (p) through (z). If an

incandescent bulb IS found, use Configuration B as shown in Figure 53 and Figure 54,

and install using Steps (aa) through (mm).

p) Attach the Headlight Bracket (P/N 113374-1-103) on the left side of the vehicle using the

hardware, as shown in Figure 51.

q) Route the Pigtail Adapter (P/N 111438-4) through the hole in the armor and cab, as

shown in Figure 51. Insert the rubber grommet into the hole located at the center of the

Light Cover (P/N 113379-1-103) that was installed in Step (f). Connect the

corresponding wire leads located inside the cab.

r) Attach the Marker Light to the Headlight Bracket using the hardware shown in Figure 51.

s) Reconnect the corresponding wire leads on the Marker Light.

Attach the Headlight to the Headlight Bracket using the hardware that was previously

removed and re-connect the corresponding wire leads on the Headlight.

u) Attach the Headlight Bracket (P/N 113374-3-103) on the right side of the vehicle using

the hardware shown in Figure 52.

v) Route the Pigtail Adapter (P/N 111438-4) through the hole in the armor and cab as

shown in Figure 52. Insert the rubber grommet into the hole located at the center of the

Light Cover (P/N 113379-1-103) that was installed in Step (f). Connect the

corresponding wire leads located inside the cab.

w) Attach the Marker Light to the Headlight Bracket using the hardware shown in Figure 52.

x) Re-connect the corresponding wire leads on the Marker Light.

y) Attach the Headlight to the Headlight Bracket using the hardware that was previously

removed and re-connect the corresponding wire leads on the Headlight.

z) Attach the previously removed Weight Marker to the Headlight Bracket using the

hardware shown in Figure 52.

0037 00-80