TB 9-2320-364-13&P-2
SIDE BLAST DEFLECTOR REPLACEMENT - CONTINUED
0026 00
REMOVAL
1.
Attach and secure lifting device under side blast deflector (11).
N OT E
Bolt lengths are not the same. Tag bolts to ensure correct installation.
2.
With assistance, remove locknut (17), washer (18), bolt (5), washer (6), and doubler plate (24) from front of side blast
deflector (11). Discard locknut.
3.
Remove two locknuts (15), washers (16), bolts (7), and washers (8) from front of side blast deflector (11). Discard lock-
nuts.
4.
Remove two locknuts (12), washers (13), stud plate (23), and cover panel (14) from side blast deflector (11). Discard
locknuts.
5.
Remove locknut (21), washer (22), bolt (1), and washer (2) from front of side blast deflector (11). Discard locknut.
6.
Remove two locknuts (19), washers (20), bolts (3), washers (4), and doubler plate (24) from front of side blast deflector
(11). Discard locknuts.
7.
Remove four bolts (9) and washers (10) from rear of side blast deflector (11).
WARN I N G
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
N OT E
Left side blast deflector weighs 178 lb (80.7 kg).
Right side blast deflector weighs 196 lb (89 kg).
8.
Use lifting device to remove side blast deflector (11).
0026 00-2