|
| |
TM 9-2320-364-10
3-86
3-9. BEACON LIGHT INSTALLATION/REMOVAL (CONT).
(5)
Align three holes in beacon light (5) with toggle bolts (1) and position
beacon light on beacon light mounting bracket (2).
(6)
Install three nuts (8) on toggle bolts (1) until nut contacts beacon light (5).
Turn nut one additional turn.
(7)
Position three lockwashers (9) and nuts (8) on toggle bolts (1).
Bottom nut must be held while top nut is tightened. Failure to
comply will cause damage to equipment.
(8)
While holding bottom nuts (8), tighten top nuts (8) until lockwashers (9) are
fully compressed.
If toggle bolts extend more than five threads past the end of
top nut, they must be cut off or rotating light will hit them.
Failure to comply will cause damage to equipment.
NOTE
Perform Step (9) if toggle bolts extend more than five
threads past top nut.
(9)
Cut off excess toggle bolt (1).
|
