|
| |
TM 9-2320-364-10
G-1
APPENDIX G
LUBRICATION INSTRUCTIONS
Section I. INTRODUCTION
G-1. SCOPE.
This appendix gives lubrication requirements for the M1074 and M1075 series PLS
which are the responsibility of the operator/crew.
G-2. GENERAL LUBRICATION REQUIREMENTS.
a.
Maintaining Lubricant Levels. Lubricant levels must be checked as
specified in the PMCS (Chapter 2, Section II) and Lubrication Table. Steps must be
taken to replenish and maintain lubricant levels.
Drycleaning Solvent (P-D-680) is TOXIC and flammable.
Wear protective goggles, face shield, and gloves; use only in a
well-ventilated area; avoid contact with skin, eyes, and clothes,
and do not breathe vapors. Keep away from heat or flame.
Never smoke when using solvent. The flashpoint for Type II
Drycleaning Solvent is 140 degrees F (60 degrees C) and Type
III Drycleaning Solvent is 200 degrees F (93 degrees C).
Failure to do so may result in injury or death to personnel.
If personnel become dizzy while using cleaning solvent,
immediately get fresh air and medical help. If solvent contacts
skin or clothes, flush with cold water. If solvent contacts eyes,
immediately flush eyes with water and get immediate medical
attention.
b.
Cleaning Fittings Before Lubrication. Clean parts with Dry Cleaning
Solvent P-D-680 or equivalent. Dry before lubricating. Dotted arrow points
indicate lubrication on both sides of the equipment.
c.
Lubrication After Fording. If fording operation occurs, lubricate all
fittings below fording depth and check submerged gear boxes for presence of
water.
d.
Lubrication After High-Pressure Washing. After a thorough washing,
lubricate all grease fittings and oil can points outside and underneath vehicle.
e.
Localized Views. A reference to the appropriate localized view is given
after most lubrication entries. Localized views begin on page G-13.
|
