|
| |
TM 9-2320-364-10
2-177
NOTE
Transfer case has High, Neutral and Low ranges. The operator
must ensure the transfer case is in the proper range before
proceeding.
If TRANSFER CASE shift lever is hard to move, push in button
and set transmission range selector to Drive (D) then back to
Neutral (N). If transfer case will not shift, select Reverse (R) then
Neutral (N) and try to shift the TRANSFER CASE lever again. If
transfer case will still not shift, select Drive (D) then back to
Neutral (N).
d.
Select transfer case range:
NOTE
Refer to Table 1-28 for additional information.
(1)
Set TRANSFER CASE shift lever (3) to H (HI) for highway driving (CTIS
set to HIGHWAY) and secondary roads (CTIS set to cross-country).
(2)
Set TRANSFER CASE shift lever (3) to L (LO) for adverse off-road
driving and steep grades (CTIS set to MUD, SAND and SNOW or
EMERGENCY).
e.
Push in buttons to set the transmission range selector (2) to desired position.
|
