|
| |
TM 9-2320-364-10
2-267
(9)
Stop truck when lift-hook (10) touches flatrack.
(10)
Leave truck in reverse gear with engine at idle.
Ensure parking brake is not applied during unload sequence or
damage to equipment may result.
Do not use Reverse (R) to back up truck while hook arm is
attached to flatrack or damage to LHS will occur.
(11)
Move joystick (1) to LOAD to engage lift-hook (10) and hook-bar (8).
(12)
If lift-hook (10) fails to engage hook-bar (8):
(a)
Release joystick (1).
(b)
Set transmission range selector (7) to Drive (D), release service brake
pedal (9) and move truck forward just clear of flatrack.
(c)
Move joystick (1) to UNLOAD until lift-hook (10) is below level of
hook-bar (8).
(d)
Repeat Steps (8) through (11).
|
