|
| |
TM 9-2320-364-10
2-281
NOTE
Engine speed should be set at idle. However, slight
increase in engine speed may be necessary depending on
terrain.
(12)
Set transmission range selector (7) to Drive (D) and release service brake
pedal (9).
(13)
Move the joystick (1) to LOAD momentarily and then to UNLOAD to let
lift-hook (10) disengage from hook-bar (8). Repeat Step (13) until lift-hook
disengages.
(14)
Move the truck forward approximately 5 ft. (1.5 m).
(15)
Stop the truck and set the transmission range selector (7) to Neutral (N).
To avoid equipment damage, visually check that main frame
cylinders have completed full retraction.
Reduce speed to idle in last 12 in. (30 cm) of travel to prevent
damage to cylinders.
(16)
Move the joystick (1) to LOAD and hold in this position until main frame
cylinders are fully retracted.
|
