|
| |
TM 9-2320-364-20-2
2-890
9. CODE 32: TRANSMISSION DIRECTION SIGNAL (CONT).
“CHECK TRANS” light ON and
transmission in neutral hold.
Forward signal identified.
Reverse signal identified.
Open/short inside transmission.
Wire 101/118 faulty.
KNOWN INFO
POSSIBLE PROBLEMS
TEST OPTIONS
REASON FOR QUESTION
Continuity test.
STE/ICE-R #91.
If a pressure switch or wiring to
Transmission ECU is faulty,
ATEC will register a code 32
fault. Transmission direction of
operation will be restricted
depending on switch failure.
YES
NO
Go to Step 4 of this
Fault.
3.
Is continuity measured
between wires 101 and 118 at
transmission bulkhead
connector, terminals E and F?
Fault is in
transmission. Notify
DS Maintenance.
WARNING
“CHECK TRANS” light ON and
transmission in neutral hold.
Forward signal identified.
Reverse signal identified.
Open/short inside transmission.
Wire 101/118 faulty.
KNOWN INFO
POSSIBLE PROBLEMS
TEST OPTIONS
REASON FOR QUESTION
Continuity test.
STE/ICE-R #91.
If a pressure switch or wiring to
Transmission ECU is faulty,
ATEC will register a code 32
fault. Transmission direction of
operation will be restricted
depending on switch failure.
YES
NO
Go to Step 5 of this
Fault.
4.
Is continuity measured
between wires 101 and 116 at
transmission bulkhead
connector, terminals E and
G?
Fault is in
transmission. Notify
DS Maintenance.
WARNING
Read WARNING
on Page 2-891
Read WARNING
on Page 2-891
|
