|
| |
TM 9-2320-364-20-2
2-892
9. CODE 32: TRANSMISSION DIRECTION SIGNAL (CONT).
5.
Repair wire(s) 101
and/or 118 (see
schematic Fig 2-22) or
notify DS
Maintenance.
Verify repair, go to
Step 6 of this Fault.
NO
“CHECK TRANS” light ON and
transmission in neutral hold.
Forward signal identified.
Reverse signal identified.
Transmission internal wiring
and forward pressure
switch OK.
Wire 101/118 faulty.
KNOWN INFO
POSSIBLE PROBLEMS
TEST OPTIONS
REASON FOR QUESTION
Continuity test.
STE/ICE-R #91.
If a pressure switch or
cab/transmission wiring to
transmission ECU is faulty,
ATEC will register a code 32
fault. Transmission direction of
operation will be restricted
depending on switch failure.
WARNING
Is continuity measured on
wires 101 and 118 between
transmission connector MC19
and ATEC ECU connector
MC10?
YES
Read WARNING
on Page 2-893
|
