| |
TM 9-2320-364-20-2
2-921
(1) Disconnect transmission connector
MC19 from transmission bulkhead
connector.
(2) Connect breakout harness
transmission end connector to
transmission bulkhead connector.
(3) Set multimeter select switch to ohms.
(4) Read resistance between terminal C
and T of breakout harness.
(a) If 9 to 20 ohms resistance are
not present, wiring inside
transmission and/or solenoid A is
faulty. Notify DS Maintenance.
(b) If 9 to 20 ohms are present, go to
Step (5) below.
(5) Is there continuity between terminal C
and a known good ground?
(a) If there is no continuity, wiring
inside transmission and solenoid
A is OK.
(b) If there is continuity, wiring inside
transmission and/or solenoid A is
faulty. Notify DS Maintenance.
CONTINUITY TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
|