|
| |
TM 9-2320-364-20-2
2-981
(1) Remove dust cover from DCA
connector MC39.
(2) Connect DCA cable W1 to the
vehicle test meter (VTM) and DCA
connector.
(3) Power up STE/ICE-R VTM in the
DCA mode (TM 9-4910-571-12&P).
(4) Perform a confidence test.
(5) Set TEST SELECT switches to 37.
(6) Start engine (TM 9-2320-364-10).
(7) Set STE/ICE ZERO OFFSET switch
to ON.
(8) Perform offset test.
(9) Press and release TEST button.
(a)
If engine oil temperature is
greater than 250F (121C),
perform Steps (10) through (13)
below and notify DS Maintenance.
(b)
If engine oil temperature is
between 200F and 250F (93C
and 121C), engine oil
temperature is OK.
(10) Turn OFF ENGINE switch.
(11) Set STE/ICE ZERO OFFSET switch
to OFF.
(12) Disconnect DCA cable W1.
(13) Install dust cover on DCA connector
MC39.
STE/ICE-R #37 ENGINE OIL
TEMPERATURE TEST
|
